tech:network:virl:connect-to-physical-network:connect-to-physical-network
Table of Contents
Cisco VIRL: Communicate with external physical network
- Require Your Lab Internet connectivity?
- Require Your Lab communicate outside physical switches?
Notice
- by default VIRL 1.6 has no physical network connectivity
Prerequisite
- 5 interfaces configured.
- use Flat interface in this case.
- VMware vSphere Hypervisor (ESXi) 6.5
You must stop all simulations before this configuration!
Open UWM, configure following VIRL appropriate interface mapping.
ESXi server vSwitch configuration is here.
References
tech/network/virl/connect-to-physical-network/connect-to-physical-network.txt · Last modified: 2019/11/27 12:56 by wnoguchi
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
