User Tools

Site Tools


tech:network:cisco:dual-stack:dual-stack

Dual Stack

Dual Stack

Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#hos
Router(config)#hostname R1
R1(config)#ip rou
R1(config)#ip routi
R1(config)#ip routing
R1(config)#ipv6
R1(config)#ipv6 rou
R1(config)#ipv6 unicast
R1(config)#ipv6 unicast-routing
R1(config)#int gig0/1
R1(config-if)#ipv addr 192.168.0.254 255.255.255.0
                                        ^
% Invalid input detected at '^' marker.

R1(config-if)#ip addr 192.168.0.254 255.255.255.0
R1(config-if)#ipv6
R1(config-if)#ipv6 add
R1(config-if)#ipv6 address 2011:321:ab12:11::1/64
R1(config-if)#no shut
R1(config-if)#
*Jul  9 22:49:47.067: %LINK-3-UPDOWN: Interface GigabitEthernet0/1, changed state to up
*Jul  9 22:49:48.067: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to up

NAT-PT

  • NAT-PT(Protocol Translation)
R1(config)#ipv6 nat prefix 2001:0db8::/96
R1(config)#
*Jul  9 22:58:37.155: %LINEPROTO-5-UPDOWN: Line protocol on Interface NVI0, changed state to up

NAT-PT implementation is deprecated.

Use NAT64.

References

tech/network/cisco/dual-stack/dual-stack.txt · Last modified: 2018/07/10 09:33 by wnoguchi